Master-force 241-0436 Manuel de l'opérateur télécharger pdf (Page 12)

Page 11

OPERATION

The LED worklight, located on the front

of the Drill, will illuminate when the

trigger switch is depressed. This provides

additional light on the surface of the work-

piece for operation in lower-light areas. The

LED worklight will turn off when the trigger

switch is released.

INSTALLING BITS (FIG.5)

FIG. 5

1. Lock the switch trigger by placing the

direction of rotation selector in center

(OFF) position.

2. Open or close the chuck jaws to a point

where the opening is slightly larger than

the bit size you intend to use. Also, raise

the front of the drill slightly to keep the

bit from falling out of the chuck jaws.

3. Insert the drill bit straight into the chuck

the full length of the jaws.

4. To tighten: grasp and hold the tool with

one hand, while rotating the chuck with

your other hand.

NOTICE: Rotate the chuck in the direction

of the arrow marked LOCK to tighten the

chuck jaws. Do not use a wrench to tighten

or loosen the chuck jaws.

REMOVING BITS (FIG.5)

1. Lock the switch trigger by placing the

direction of rotation selector in center

position.

2. To loosen the chuck jaw: grasp and hold

the tool with one hand, while rotating the

chuck with your other hand.

NOTICE: Rotating the chuck in the direction

of the arrow marked UNLOCK to loosen the

chuck jaws. Do not use a wrench to tighten

or loosen the chuck jaws.

3. Remove the drill bit from the chuck jaws.

WARNING:

The bit may be hot after

use. Wear protective gloves or wait until the

bit has cooled down before removing the bit.

WARNING:

Make sure to insert the

drill bit straight into the chuck jaws. Do not

insert the drill bit into the chuck jaws at an

angle then tighten. This could cause the drill

bit to be ejected from the drill, resulting in

possible serious personal injury or damage

to the chuck.

BIT STORAGE (FIG. 6)

FIG. 6

When not in use, bits provided with the drill

can be placed in the storage area located on

the base of the drill.

UNLOCK (Release)

Drill bits

LOCK (Tighten)

Chuck jaws

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire