Master-force 241-0854 Manuel de l'opérateur télécharger pdf (Page 18)

Page 17

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION

The tool will not start.

The tool is not plugged

into a power source.

Plug the tool into a power source.

The circuit breaker is

tripped.

Reset the circuit breaker. (If the

product repeatedly causes the

circuit breaker to trip, discontinue

use immediately and have the

tool serviced at an authorized

service center.

The cord is damaged.

Have the cord or switch replaced

at an authorized service center.

The motor is overheating.

Too much pressure is

being exerted on the tool.

Let the tool run under no load to

cool down.

Make sure the cooling

vents are free from dust

and obstacles.

Clean and clear the vents. Do not

cover vents with your hand during

operation.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire